SETTINGS STUCK ON INITIALIZING UPDATES UPDATE

If this does not work, try hitting Right arrow And X.ĭepending on your model this procedure may or may not work. With the printer on, hit Copy And X ( Cancel button above the copy button) until it says Permanent storage initialize.Plug the power cable back in and turn the printer back on.Turn off the printer and unplug ALL cables including the USB, network and power cable.

To bypass the initializing phase, perform the following steps: Step 2: Bypass The Initializing Phaseįor some HP models, you can bypass the initializing phase all together. That’s all there is to it! This should get the printer unstuck for most users. Manually turn the printer back on if it does not turn back on automatically. Your printer should now reset and turn back on automatically. To hard reset your printer, first disconnect the power cord from BOTH the printer and the power source while the printer is ON.Īfter 60 seconds, reconnect the power cord to the back of the printer and the power outlet. Performing a “hard reset” is a simple solution that often solves a number of different HP Printer issues. Then we will work our way to some move involved troubleshooting steps. We’ll start with some of the easier more obvious fixes. Read on for further step-by-step instructions and troubleshooting steps you can take to get your printer unstuck today! As a final measure, try reflowing the motherboard.

SETTINGS STUCK ON INITIALIZING UPDATES UPDATE

If the issue persists, cold reset the printer to restore factory default settings and update the firmware. If you encounter your HP Printer stuck on initializing, perform a hard reset, bypass the initializing phase, and power drain the printer motherboard. Conclusion HP Printer Stuck On Initializing.

Settings stuck on initializing updates